HP T1936AA - Digital Sending Software Support Manual page 41

Control panel messages (continued)
Message
Authentication failed:
Error Code xxxx
The Digital Sending
Service at 15.xx.yy.zz
does not service this
MFP. Contact
administrator
Digital Send
Communication Error.
ENWW
Description and actions
Authentication failed for a reason other than the user-entered information
was incorrect. The following error codes might appear:
: Unexpected failure. Something unexplained occurred.
201
: Authentication not available. The service is too busy to accept the
202
request.
: Authentication not supported.
203
: Encryption not supported.
204
: Invalid parameter.
205
: Invalid LDAP logon method; logon method not supported by the
206
LDAP server.
: Unexpected LDAP failure. Either the LDAP server or the
207
connection is bad.
: LDAP server not available; it is either not a server or not running
208
LDAP.
: LDAP server is too busy.
209
: Invalid LDAP user name. User does not have access to the LDAP
210
server.
: Invalid LDAP user password.
211
: Invalid LDAP user credentials.
212
: Invalid LDAP user domain.
213
: Invalid LDAP privileges; user does not have proper permission to
214
access the LDAP database.
: Invalid LDAP user record; user does not have an entry in the LDAP
215
database.
: Invalid LDAP container; invalid search root.
216
: Invalid LDAP name attribute.
217
: Invalid LDAP e-mail name attribute.
218
: Invalid fax attribute.
219
: Invalid LDAP display name attribute.
220
: No e-mail address at the specified attribute.
221
: Tested user does not have an account on the domain.
222
: Tested user's password is not valid.
223
: Tested user's credentials are not valid.
224
: Tested user's domain is invalid.
225
: Test account exists but is not accessible.
226
: The server did not contain the necessary information to locate the
227
user's home mail server.
The license for the MFP was removed from the Digital Sending service at IP
address 15.xx.yy.zz, but the service was unable to communicate with the
MFP at the time. Therefore, the MFP was not notified that it was no longer
licensed. When this error occurs, the MFP will be updated to indicate that it
is not licensed by a Digital Sending Service, so the message will only
appear once.
Re-license the MFP.
The MFP was unable to connect to HP DSS v.
Verify HP DSS v. is running.
4
Verify HP DSS v. and the MFP are on the network.
4
Turn the MFP off and back on.
Restart HP DSS v.
4
Restart the computer on which HP DSS v.
4
is installed.
4
Control panel messages 35