Table of Contents
Advertisement
31. Fill the rest of the groove with Loctite* 498 Adhesive. Verify under the microscope
that the thermocouple wire is below the surface along the entire length of the IHS
groove (Figure 7-33).
Figure 7-33. Filling Groove with Adhesive
32. To speed up the curing process apply Loctite* Accelerator on top of the Adhesive
and let it set for a couple of minutes (Figure 7-34).
Figure 7-34. Application of Accelerant
100
Case Temperature Reference Metrology
Thermal and Mechanical Design Guidelines
Advertisement
Table of Contents
Need help?
Do you have a question about the E6700 - Core 2 Duo Dual-Core Processor and is the answer not in the manual?
Questions and answers