Unit 262 Thread Milling - HEIDENHAIN ITNC 530 - PILOT SMART NC Manual

Unit 262 Thread Milling

Parameters on the overview form:
U T: Tool number or name (switchable via soft key)
U S: Spindle speed [rpm] or cutting speed [m/min or ipm]
U F: Feed rate for milling
U
Diameter: Nominal diameter of the thread
U Thread pitch: Pitch of the thread
U Depth: Depth of the thread
U Machining positions (see "Defining Machining Positions" on page 149)
Additional parameters on the tool detail form:
U DL: Delta length for tool T
U
DR: Delta radius for tool T
U
M function: Any miscellaneous function M
U Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3
U Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent)
77