Unit 201 Reaming
Parameters on the overview form:
U
T: Tool number or name (switchable via soft key)
U
S: Spindle speed [rpm] or cutting speed [m/min or ipm]
U
F: Reaming feed rate [mm/min] or FU [mm/rev]
U
Depth: Reaming depth
U
Machining positions (see "Defining Machining Positions" on page 149)
Additional parameters on the tool detail form:
U
DL: Delta length for tool T
U
M function: Any miscellaneous function M
U
Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3
U
Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent)
64