HEIDENHAIN ITNC 530 - PILOT SMART NC Manual page 41

Copying units
You can copy individual machining units very easily with the familiar
Windows shortcut keys:
Ctrl+C to copy the unit
Ctrl+X to cut the unit out
Ctrl+V to insert the unit behind the active one
If you want to copy two or more units at the same time, proceed as
follows:
U Switch to the top level of the soft-key row
U Use the arrow keys or the mouse to select the first unit
to be copied
U Activate the marking function
U Use the cursor keys or the MARK NEXT BLOCK soft key
to select all units to be copied
U Copy the marked block to the clipboard (also works with
Ctrl+C)
U Use the cursor keys or soft key to select the unit just
before the desired insertion point for the copied block
U Insert the block from the clipboard (also works with
Ctrl+V)
41