HEIDENHAIN ITNC 530 - PILOT SMART NC Manual page 93

Additional parameters on the pocket parameters detail form:
U
Allowance for side: Finishing allowance for the side
U Allowance in depth: Finishing allowance for the depth
U Infeed for finishing: Infeed for finishing on the side. If nothing is
entered, finishing is performed in one infeed
U F rate for finishing: Feed rate for finishing [mm/min], FU [mm/rev]
or FZ [mm/tooth]
U
Angle of rotation: Angle by which the entire pocket is rotated
U Slot position: Position of the slot referenced to the programmed
position
Globally effective parameters on the global data detail form:
U Setup clearance
U 2nd setup clearance
U Feed rate for traversing between machining positions
U Climb milling, or
U Up-cut milling
U Plunge in a helical motion, or
U Plunge in a reciprocating motion, or
U Plunge vertically
93