HEIDENHAIN ITNC 530 - PILOT SMART NC Manual page 148

Unit 40 Conversational Programming
Use this unit to insert conversational dialog sequences between
machining blocks. It can always be used in the following cases:
You require TNC functions for which form entry is not yet available
You want to define OEM cycles
There is no limit to the number of conversational
programming blocks that can be entered per conversational
dialog sequence.
The following conversational functions, for which no form input is
possible, can be inserted:
Path functions L, CHF, CC, C, CR, CT, RND via the gray path function keys
STOP block via the STOP key
Separate M-function block via ASCII key M
Tool call with the TOOL CALL key
Cycle definitions
Touch-probe cycle definitions
Program section repeats/subprogram technique
Q-parameter programming
148