HEIDENHAIN ITNC 530 - PILOT SMART NC Manual page 123

Unit 232 Face Milling
Parameters on the overview form:
U T: Tool number or name (switchable via soft key)
U S: Spindle speed [rpm] or cutting speed [m/min or ipm]
U F: Feed rate for milling [mm/min] or FU [mm/rev] or FZ [mm/tooth]
U
Milling plan: Selection of the milling plan
U Starting point in 1st axis: Starting point in the reference axis
U Starting point in 2nd axis: Starting point in the minor axis
U Starting point in 3rd axis: Starting point in the tool axis
U
End point in 3rd axis: End point in the tool axis
U Allowance in depth: Finishing allowance for the depth
U 1st side length: Length of the surface to be milled in the reference
axis, referenced to the starting point
U 2nd side length: Length of the surface to be milled in the minor axis,
referenced to the starting point
U
Maximum infeed: Maximum infeed per cut
U Clearance to side: Lateral distance by which the tool moves beyond
the surface
123