HEIDENHAIN ITNC 530 - PILOT SMART NC Manual page 117

Additional parameters on the tool detail form:
U
DL: Delta length for tool T
U DR: Delta radius for tool T
U DR2: Delta radius 2 (corner radius) for tool T
U M function: Any miscellaneous function M
U
Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3
U Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent)
Additional parameters on the milling parameters detail form:
U Infeed for finishing: Infeed for finishing on the side. If nothing is
entered, finishing is performed in one infeed
U F rate for finishing: Feed rate for finishing [mm/min], FU [mm/rev]
or FZ [mm/tooth]
Globally effective parameters on the global data detail form:
U Setup clearance
U 2nd setup clearance
U
Climb milling, or
U Up-cut milling
U Plunge in a helical motion, or
U Plunge in a reciprocating motion, or
U
Plunge vertically
117