Get Parameter Definition By Id - Lexicon RV-8 V2.0 - SERIAL PROTOCOL DEFINITIONS REV 1-8 Manual

Lexicon

7.3.13 Get Parameter Definition by Id

Request to RV-8 for a Parameter Definition by Parameter Id. RV-8 will respond with "RV8
Parameter Definition Packet".
7.3.13.1 Command Packet Description
Application Header:
Command MC_GET_PARAM_BY_ID
Data Count 2
Application Data:
Data[0]
Data[1]
7.3.13.2 Data Description
ParamId:
Data Type:
Max Value:
7.3.13.3 Data Validation
If the ParamId is not a valid Id the RV-8 will respond with a NAK packet and error code DC_
INVALID_PARAM_ID.
7.3.13.4 Parameter Definition Response Packet
The following Packet has been defined as follows for RV-8 V1.00. Future releases may modify
this definition.
Application Header:
Command
Data Count
Application Data:
Data[0]
Data[1]
Data[2]
Data[3]
Data[4]
Data[5]
Data[6]
Data[7-27]
Data[28]-Data[108]
Data[108]
7.3.13.5 Data Description
ParamId:
Data Type:
Max Value:
ParamId(LSB)
ParamId(MSB)
Unsigned 16 bit Integer
Max Parameter Count as reported by the RV-8 Unit Configuration
Response Packet in 7.3.16.2
MC_SYS_PARAM_DEF_PKT 0x8F
110
ParamId(LSB)
ParamId(MSB)
ParamType
MAX Value(LSB)
MAX Value(MSB)
MIN Value(LSB)
MIN Value(MSB)
CurrentValue[0 -20]
Parameter Path
Read Only
Unsigned 16 bit Integer
Max Parameter Count as reported by the RV-8 Unit Configuration
Response Packet in 7.3.16.2
RV-8 Serial Communications Protocol
0x35
0x02
nn
nn
0x6E
nn
nn
nn
nn
nn
nn
nn
nn nn nn...
ch ch ch ...
0x00
nn
22