No Acknowledge; Host Initiated Command Packets; Reset Unit; Get Custom Name - Lexicon RV-8 V2.0 - SERIAL PROTOCOL DEFINITIONS REV 1-8 Manual

Lexicon
7.2.1.2 Data Description
Command:
DataType:

7.2.2 No Acknowledge

7.2.2.1 Packet Description
7.2.2.2 Data Description
Command:
DataType:
ErrorCode:
DataType:

7.3 Host Initiated Command Packets

The RV8 serial communication protocol has been designed to respond to the following
commands as described below. Each command is transmitted to the RV8 with the identified
parameters. If the command is successfully received and processed by the RV8, the unit will
respond with the described response packet or action.

7.3.1 Reset Unit

Commands the RV8 to soft reset.
7.3.1.1 Command Packet Description
7.3.1.2 RV-8 Response
The RV-8 will perform an internal reset. After reset the RV-8 will go through a soft power-up
initialization. This includes transmitting the "Wakeup Notification Packet". A soft reset does not
reinitialize the RV-8. Nonvolatile RAM is maintained.

7.3.2 Get Custom Name

Request to RV-8 for an effect definition. RV-8 will respond with "Custom Name Packet".
Valid RV8 command as defined in Appendix A Command Codes.
Application Header:
Command DC_NACK
Data Count 2
Application Data:
Data[0] Command
Data[1] ErrorCode
Valid RV8 command as defined in Appendix A Command Codes.
Error code as defined in Appendix B Error Codes.
Application Header:
Command DC_CMD_RESET
Data Count 0
Application Data:
N/A
RV-8 Serial Communications Protocol
0xE1
0x02
nn
nn
0x10
0x00
13