Set Zone2 Left/Right Balance; Set Custom Name - Lexicon MC-8 V1.0 - SERIAL COMMUNICATIONS PROTOCOL DEFINITION REV 1-4 Manual

Lexicon, Inc.
MC-8 Serial Communications Protocol
If a value is passed that exceeds the maximum value of that parameter the MC-8 will ignore the command and
transmit a NAK command with an error code DC_INVALID_DATA.

6.3.14 Set Zone2 Left/Right Balance

Commands MC-8 to set the Zone 2 balance to the value in this packet.
This command has been maintained for backward compatibility with MC-1. In order to maintain backward
compatibility, the MC-8 Parameters have been mapped to the MC-1 parameters as described in each Data
Description. MC-8 users should be using the command described in
6.3.14.1 Packet Description
Application Header:
Command
Data Count 1
Application Data:
Data[0]
6.3.14.2 Data Description
Value:
Data Type:
Max:
Conversion:
6.3.14.3 MC-8 Response
The MC-8 will assign the value from the packet to the Zone 2 balance.
6.3.14.4 Data Validation
If a value is passed that exceeds the maximum value of that parameter the MC-8 will ignore the command and
transmit a NAK command with an error code DC_INVALID_DATA.

6.3.15 Set Custom Name

Sets the Custom Name that can be displayed when the unit powers up.
6.3.15.1 Packet Description
Application Header:
Command
Data Count
Application Data:
Data[0]
Data[1]-Data[DataCount-1]
6.3.15.2 Data Description
CustomNameEnable:
DataType:
TRUE:
© 2003 Lexicon, Inc. All rights reserved.
DC_CMD_SET_ZONE2_BALANCE
Value
Unsigned 8 bit integer
32
0 = Left
32 = Right
DC_CMD_SET_CUST_NAME 0x2C
Number of characters in
CustomName + 2
CustomNameEnable
CustomName
Enables/Disables the Custom Name Display.
Boolean
CustomName Enabled
Printed on: 04/01/03
6.3.39 MC8_Set_Zone2_Left_Right_Balance).
0x28
0x01
nn
nn
nn
ch ch ch ... 0x00
25 of 80