Set Zone2 Volume - Lexicon MC-8 V1.0 - SERIAL COMMUNICATIONS PROTOCOL DEFINITION REV 1-4 Manual

Lexicon, Inc.
MC-8 Serial Communications Protocol
6.3.12.1 Command Packet Description
6.3.12.2 Data Description
EffectId:
Data Type:
Definition/Conversion:
6.3.12.3 MC-8 Response
The MC-8 will load the desired effect.
6.3.12.4 Data Validation
If a value is passed that exceeds the maximum value of that parameter the MC-8 will ignore the command and
transmit a NAK command with an error code DC_INVALID_DATA.

6.3.13 Set Zone2 Volume

Commands MC-8 to set the Zone 2 volume with the value in this packet.
This command has been maintained for backward compatibility with MC-1. In order to maintain backward
compatibility, the MC-8 Parameters have been mapped to the MC-1 parameters as described in each Data
Description. MC-8 users should be using the command described in
6.3.13.1 Command Packet Description
Application Header:
Command
Data Count 1
Application Data:
Data[0]
6.3.13.2 Data Description
Value:
Data Type:
Max:
Conversion:
6.3.13.3 MC-8 Response
The MC-8 will assign the value from the packet to the Zone 2 volume.
6.3.13.4 Data Validation
© 2003 Lexicon, Inc. All rights reserved.
Application Header:
Command DC_CMD_SET_EFFECT
Data Count 1
Application Data:
Data[0] EffectId
Unsigned 8 bit integer
Appendix I MC-1 to MC-8 Effect ID
DC_CMD_SET_ZONE2_VOLUME
Value
Unsigned 8 bit integer.
92
0 = -80 dB
92 = +12 dB
Printed on: 04/01/03
0x24
0x01
nn
Map.
6.3.38 (MC8_Set_Zone2_Volume).
0x27
0x01
nn
24 of 80