Install The Cluster Service Software And Configuring The Node A - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Installation Manual

[Enter your Document Title]
a RAID 1 configuration.
During the Cluster service installation, a drive letter must be provided for the
quorum disk. The drive letter Q is recommended for use by the quorum disk.
Configuring Shared Disks
Use Disk Management to configure the quorum and shared disk resources.
Verify that all shared disks are formatted as NTFS and are designated as Basic.
Verifying Disk Access and Functionality
Write a file to each shared disk resource to verify functionality.
At this time, shut down the Node A, power on Node B, and repeat the Verifying
Disk Access and Functionality step above. When it has been verified that both
nodes can read and write from the disks, shut down Node B, power on Node A,
and then continue with this guide.

Install the Cluster Service Software and Configuring the Node A

Note: During installation of the Cluster service on Node A, Node B must be
shut down. All shared storage devices should be powered up.
In the first phase of installation, all initial cluster configuration information
must be supplied to create the cluster. This is accomplished using the Cluster
Service Configuration Wizard.
1. Click Start, click Settings, and click Control Panel.
Double-click Add/Remove Programs.
2.
Double-click Add/Remove Windows Components.
3.
Select Cluster Service. Click Next.
4.
5. When prompted for files on the Windows Powered OS CD or the Windows 2000 SP3
cd, browse to the directory C:\Compaq\Windows Components\i386.
The window shown in Figure 7 below appears. Click I Understand to accept the
6.
condition that the Cluster service is supported on hardware from the Hardware
compatibility List only.
[Document Restriction Notice]
13