Upgrading Swvr And Sfu To Be Cluster Aware - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Installation Manual

[Enter your Document Title]
Upgrading
SWVR and SFU
to be cluster
aware
For cluster configurations, the Virtual Replicator and Services For UNIX software must be
updated. If the e7000 is not being installed as part of a e7000 cluster, please skip this
section.
If the Cluster Setup Tool was not used for cluster configuration then follow the steps
provided below to update SWVR, SFU and NAS Datacopy to be cluster aware. If the
Cluster Setup Tool was used to configure the cluster this section may be skipped.
SANWorks Virtual Replicator (SWVR) and Services for UNIX (SFU) must be upgraded
after the successful installation of the Cluster Service on both nodes.
This tool will make SWVR cluster-aware and install the 116B and 116C patches. It is not
necessary to reinstall the 116B and 116C patches once this process is complete. This
must be completed remotely. Do not run the update utility locally on the NAS cluster
node.
Procedures:
1. Ensure that all cluster resources reside on NODE A
2. From a remote node, click on the Internet Explorer icon in the fast start tray. A
prompt for a username and password will appear.
administrator, the password should be null if this is a new install (the password
is the same password that is used for the local administrator account on the
server. The default administrator password may have been changed earlier in
the installation when Rapid Startup prompted for an administrator password.
3. Navigate to the WEBUI for NODE B
a. In a web browser's address field type the hostname or IP address for
NODE B followed by port 3201. For example: NODEB:3201
4. From the frame on the left choose "Cluster Setup Tool".
a. Choose "Is this a Cluster Recovery" and select NEXT. (This option is at
the very bottom of the page, which might require scrolling down to see
the option.) Selecting the Cluster Recovery option allows the tool to be
run close to the software update section.
5. Check the boxes to confirm that the steps have been completed and select
NEXT.
6. Check the box to validate that the Quorum disk can be seen and select NEXT.
7. Select NEXT on the Install Microsoft Cluster Services screen.
8. Check the box to validate that the cluster service has started and select NEXT.
9. Check the box to confirm that Secure Path has been configured and select
NEXT.
a. There will be two more Secure Path pages. Check the box and select
next to navigate through these pages.
10. Click the "Click here to make VR Cluster Aware". This process will uninstall
SWVR on NODE B, reboot NODE B and then reinstall SWVR on NODE B.
When this process is complete select NEXT.
11. On the "Upgrade Services for Unix" page, click the "Click here to Start the
Upgrade Process". This will reboot NODE B. When the process is complete
select NEXT.
12. Depending on the version of the system image an upgrade of StorageWorks
NAS Data Copy may also be necessary. Select the CLICK HERE TO UPGRADE
DATA COPY link. This will upgrade Data Copy. When the process is complete
select NEXT.
13. Select Finish ending the wizard.
[Document Restriction Notice]
The user name is
23