[Enter your Document Title]
However, do not let the shared disk be accessed by both nodes at the same time
until Cluster Services has been installed on at least one node.
•
All shared disks must be configured as basic (not dynamic).
All partitions on the disks must be formatted as NTFS.
•
Installation Overview
During the installation process, both nodes will be shut down and both nodes
will be rebooted. These steps are necessary to guarantee that the data on the
shared storage is not lost or corrupted. This can happen when multiple nodes try
to simultaneously write to a disk that is not yet protected by the cluster
software.
Use Table 1 below to determine which nodes and storage devices should be
presented during each step.
Step
Node 1
Setting Up
On
Networks
Setting up Shared
On
Disks
Verifying Disk
Off
Configuration
Configuring the
On
First Node
Configuring the
On
Second Node
Post-installation
On
Table 1. Power Sequencing for Cluster Installation
To configure the Cluster service on the StorageWorks NAS server, the login
account must have administrative permissions on each node. Both nodes must
be member servers within the same domain.
Setting up Networks
Note: Do not let both nodes access the shared storage devices at the same time
until the Cluster service is installed on at least one Node And that node is
online. This can be accomplished through selective storage presentation, SAN
switch zoning or having only one node online at all times.
Node 2
Storage
Comments
On
Not
Verify that all storage devices on the shared
Presented
bus are not presented.
Power on both nodes.
Off
Presented
Shutdown both nodes.
Present the shared storage
Power on Node A
On
Presented
Shut down first node.
Power on Node B.
Off
Presented
Shutdown all nodes.
Power on Node A.
On
Presented
Power on Node B after Node A was
successfully configured.
On
Presented
At this point both nodes should be on.
[Document Restriction Notice]
10
Need help?
Do you have a question about the 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server and is the answer not in the manual?
Questions and answers