Connecting To An Xp Array - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Installation Manual

[Enter your Document Title]
b. Hkey_Local_Machine\Software\Compaq\StorageworksNas
iii. Set OCU=1
iv. Set PRSstate=3
4. Obtain and install the Software solution kit for EVA VCS 2.x
5. Obtain and install Secure Path 4.0
a. After Secure Path installation, reboot and then connect the fiber cables.

Connecting to an XP array

1. Run lputilnt.exe from a command prompt and verify that the HBA driver is 5-
4.81a9 and the firmware is 3.90a7
2. When the StorageWorks NAS v1 software was published, XP array
compatibility software was not available. It will be necessary to skip the SAN
Connection tool.
3. To bypass the SAN connection tool:
a. Close Internet Explorer
b. Open regedit and navigate to the following key
i.
ii.
iii.
Obtain and install Auto Path v2.01
After Auto Path installation, reboot and then connect the fiber cables.
NOTE: Make sure to do this on both nodes before continuing.
Hkey_Local_Machine\Software\Compaq\StorageworksNas
Set OCU=1
Set PRSstate=3
[Document Restriction Notice]
7