Introduction; Quick Restore; Table Of Contents Introduction; Rapid Launch - Compaq 230039-001 - StorageWorks NAS Executor E7000 Model 904 Server Installation Manual

[Enter your Document Title]

Introduction

Quick Restore

Rapid Launch

This paper will provide a step by step process for the installation and configuration of
the e7000 v1. It is assumed that the installation will be performed on a new unit or a
unit that has just been quick restored. Additional information about any of the topics
covered in the document can be located in the Administration guide.
The NAS e7000 v1 Quick Restore CD should be labeled version 2.01.
1. Place the StorageWorks NAS Executor E7000 Quick Restore CD into the
CDROM drive on the E7000. With the CD in the CDROM tray, reboot or turn
on the server. When prompted press "Q" to begin the Quick Restore.
2. When prompted for the second CD, insert the second CD.
In a cluster configuration, time can be saved by placing CD 1 into the second Node And
begin the Quick Restore process while the Quick Restore process is running on the first
node.
The NAS e7000 includes a RapidLaunch CD that can run on any Windows-based PC
using Internet Explorer 5.5 (or greater). The WEBUI application is designed to be
graphical and easy-to-use, and to assist you in populating information necessary for
configuration.
NOTE: The RapidLaunch utility must be run on each node in a cluster.
Requirements
The following items are required to run the WebUI configuration application:
•
Windows-based PC loaded with Internet Explorer 5.5 (or greater) on the same
network segment as the NAS e7000
•
RapidLaunch CD
NOTE: The NAS e7000 is designed to be deployed without a monitor, keyboard, and mouse.
These ports are available and supported by the NAS device if used.
To initialize the NAS e7000 using the WebUI configuration application:
CAUTION: Do not power up the NAS device until steps 1-5 are completed.
1. Connect the Ethernet cables to the respective network ports of the NAS e7000.
2. Verify that the Windows-based PC client is connected to the same subnet as
the NAS e7000.
3. Power on the Windows-based PC and wait until the operating system has
completely loaded.
4. Insert the RapidLaunch CD into the CD-ROM drive.
5. The RapidLaunch CD should automatically run. If the program does not
startup automatically, the program may be run manually. Click Start select Run
on the Windows taskbar, and then type the following: {
drive}:\setup.exe.
6. Go to the NAS device and power it on. It will be several minutes before the
NAS device is accessible on the network.
7. Return to the Windows-based PC. Select StorageWorks NAS from the Show
drop down list to have RapidLaunch list all NAS devices on the network.
8. All the NAS devices found on the network are displayed. The NAS device will
be displayed in the device discovery portion of the screen as an unconfigured
device. It may take several minutes for the NAS device to be found on the
network.
NOTE: The RapidLaunch utility will refresh periodically looking for new devices on the network.
Wait for the interface to startup.
[Document Restriction Notice]
CD ROM
2