Connecting A Psu; Connecting An Ac-Input Psu - H3C SECPATH F1000-A,SECPATH F1000-A HOST Installation Manual

Table of Contents

Installation Manual

H3C SecPath F1000-A Firewall

Caution:

Laser danger: never look into the optical ports that are connected to the laser. It can

harm your eyes.

Step 1: Correctly connect one end of a fiber-optic cable to the Rx port of the

10/100/1000 Mbps interface on the firewall and the other end to the Tx port on the peer

device. Connect another fiber-optic cable between the Tx port on the firewall and the

Rx port on the peer device.

Step 2: Power up the firewall and check the status of the LINK LED of the Ethernet 1

interface. On means the Rx link is present. OFF means no Rx link is present; check the

line for the cause.

3.7 Connecting a PSU

The H3C SecPath Series Firewall can be AC-powered or DC-powered. Except for PSU,

the two models are exactly the same with respect to functionalities and other features.

Note:

If both PSUs are connected, they operate in mutual backup mode.

I. AC-input PSU

AC input: 100 VAC to 240 VAC, 50 Hz or 60 Hz

Figure 3-6 illustrates the power socket on an AC-powered firewall:

3-8

Chapter 3 Hardware Installation

Table of Contents

Do you have a question about the H3C SECPATH F1000-A,SECPATH F1000-A HOST and is the answer not in the manual?