Figure 4-2 Set Up A New Connection; Figure 4-3 Select Serial Interface - H3C SECPATH F1000-A,SECPATH F1000-A HOST Installation Manual

Installation Manual
H3C SecPath F1000-A Firewall

Figure 4-2 Set up a new connection

Step 2: Set the terminal parameters.
Set the HyperTerminal parameters of Windows98 as follows:
1) Select serial interface
Select the serial interface to be used from the Connect using drop-down list as shown in
Figure 4-3. The serial interface selected here must be the one connected to the console
cable.

Figure 4-3 Select serial interface

2) Set the serial interface
The [Port Settings] tab appears as shown in Figure 4-4, and set the serial interface
parameters as follows:
Chapter 4 Booting and Configuration
4-2