Table of Contents
Advertisement
Installation Manual
H3C SecPath F1000-A Firewall
Caution:
Before you install your device, make sure that:
You have read Chapter 2 "Preparation for Installation" carefully.
The requirements in Chapter 2 are satisfied.
3.2 Mounting the Device
You can install your device on a workbench/tabletop or in a rack.
3.2.1 Tabletop/Workbench-Mounting the Device
If a 19-inch standard rack is unavailable, you can place the firewall on a clean
workbench/tabletop. To prevent any damage, observe the following:
Ensure the table is stable and well earthed.
Reserve the clearance of 10 cm (3.9 in.) around the device for adequate
ventilation.
Do not place any heavy stuff on the device.
3.2.2 Rack-Mounting the Device
The firewall can be placed in a 19-inch standard rack. The following table shows its
dimensions:
Table 3-1 Dimensions of the firewall
H3C SecPath F1000-A
Follow these steps to install the H3C SecPath F1000-A firewall:
Step 1: Check that the rack is stable enough and properly earthed. Attach the mounting
ears to the front or rear of the chassis with screws.
Step 2: Place the device on a shelf in the rack and slide it to a proper position along the
guide rails, reserving a suitable clearance between the device and the guide rails.
Step 3: Fix the brackets to the rack posts with suitable antirust pan-head screws,
making sure that the device is securely fixed.
Model
3-2
Chapter 3 Hardware Installation
Dimensions (H × W × D)
44 × 436 × 430 mm (1.7 × 17.2 × 16.9
in.), excluding the rubber feet
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the H3C SECPATH F1000-A,SECPATH F1000-A HOST and is the answer not in the manual?
Questions and answers