Built-In Needle Threader - ELNA 7200 Instruction Manual

q
w
r

Built-in Needle Threader

Press the "Up/Down Needle" key q until the
needle is in an up position. Turn OFF the power
switch. Lower the presser foot.
Lower the needle threader lever w as far as it will
go. Hook e is automatically inserted into the
needle eye.
e
Bring the thread around guide r and under hook
e.
e
Slowly release the lever while holding the thread
end and let the needle threader return to its
original position. A loop of thread t is pulled
t
through the needle eye.
Pull the thread loop off the guide to the back and
manually bring the thread through the needle eye.
• The needle threader can be used with #11 to #16
size needles. Thread weight may vary from 30 to
100.
NOTE: Needle threader cannot be used with a
twin needle or wing needle.
If the needle threader does not catch a thread
loop, check the needle and positioning.
27