Walking Foot; Walking Foot With Quilt Guide - ELNA 7200 Instruction Manual

Walking Foot

Great for keeping quilt layers from shifting when
sewing and keeping stripes and checks matched.
How To Attach Open Toe Walking Foot
Press the "Up/Down Needle" key until the needle is
in an up position. Raise the presser foot.
Turn OFF power switch. Loosen thumbscrew and
remove shank. Place the open toe walking foot on
the presser bar with the lever over the needle clamp
screw; tighten thumbscrew. Turn ON power switch.
Select 1.
Set stitch length 2.4 - 3.5.
Set foot pressure dial between 2 and 3.
Sewing Quilt Layers
Pin quilt layers together (backing, batting/wadding
and quilt top). Draw quilting lines with a washable
fabric marker. Place quilt layers under walking foot.
Lower open toe walking foot. Sew over drawn lines.
Sewing Plaids
Match and pin plaids together. Place fabrics under
foot. Lower open toe walking foot. Remove pins as
you sew; do not sew over pins with the open toe
walking foot.
Optional: Attach Quilt Guide
Snap quilt guide down into groove on back of open
toe walking foot. Slide the quilt guide in the opening
until the desired width between the stitching rows is
set.
Pin quilt layers together. Follow marking and
sewing instructions described on page 60.
59