Warning Messages - ELNA 7200 Instruction Manual

Warning Messages

Three beep sounds will alert you to machine problems. The LCD screen will show one of these
messages.
Message Reason
Power switch is turned on while foot
control is pressed.
Power switch is turned on with the needle
in the down position.
Presser foot is up when sewing is
attempted.
While sewing, presser foot is raised.
Presser foot is up when Auto Thread Cut
Key was pressed.
If the buttonhole lever is not lowered, the
machine will stop sewing.
The machine was stopped before
lockstitch was completed.
Power switch has been turned on but
machine has not sewn when the Auto
Thread Cut Key is pressed.
Auto Thread Cut Key cannot be used
consecutively 4 times
86
What to Do
Release the foot control.
Press the "Up/Down Needle"
key.
Lower presser foot.
Lower presser foot.
Lower presser foot and press
"Auto Thread Cut" key.
Lower buttonhole lever and
begin sewing.
Start machine and allow
lockstitch to complete.
Press the "Auto Thread Cut"
key only after machine has
been sewing.