Removing The Hard Disk Drive - IBM 4800-741 Hardware Service Manual

Removing the hard disk drive

Models with the front-service housing option
For models with front-service housing installed, follow these instructions:
1. Remove the front bezel as follows:
2. See Figure 21 on page 33. Press upward on the latch and use the pull-out
3. Open the media access door by removing the two screws.
4. If installed, follow the instructions in "Removing the CD-ROM" on page 33.
5. Continue with step 4 on page 37 below.
6. To replace, reverse these steps.
For all other models:
Follow these steps to remove and replace the hard disk drive:
1. Follow the instructions in "Removing the covers" on page 29 to remove the front
2. Follow the instructions in "Removing the top plate" on page 32 to remove the
3. If installed, follow the instructions in "Removing the CD-ROM" on page 33.
36
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
a. See Figure 17 on page 29. Press the left latch and depress the center latch
to loosen the bezel.
b. Press the right latch to release the bezel and pull it forward, lifting the bezel
from the machine.
handle to extend the system unit from the housing.
Note: Be sure to a cart to support the system unit if it is completely removed.
bezel and top cover.
top plate.
Updated July 14, 2008