IBM 4800-741 Hardware Service Manual page 88

3. For each cable, insert the connector end into the system unit first, then route it
Figure 61. Extra cord length during routing
4. With the cable guide arm assembly perpendicular to the system unit, continue to
70
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
through the cable guide. You can close the velcro loop around the cord at this
time or later in the cable routing process.
Tip for routing the mouse, keyboard, and printer cables
When routing these cables, allow extra length at the connector end by
forming a loop (see Figure 61) before continuing with the cable into the
cable guide. This extra length prevents undue strain on the connector.
route the cable along the outside of the cable guide arm assembly, closing the
velcro strips where appropriate to secure.
Note: Do not plug the power cord into the receptacle at this time, or attach the
cables to the devices.
Updated July 14, 2008