Removing The Memory Modules - IBM 4800-741 Hardware Service Manual

Removing the memory modules

1. Follow the instructions in "Removing the covers" on page 29 to remove the front
2. Follow the instructions in "Removing the top plate" on page 32 to remove the
3. Follow the instructions in "Removing the air duct (Models 722, 74x, 78x, and
4. See Figure 53. Locate the memory modules and slots.
Figure 53. Opening the memory module latches
5. Press downward on the white tabs ( O ) on both sides of the memory-module
6. Touching only the upper corners of the memory module, lift it gently until the
To replace the memory modules, follow these instructions:
1. Note the alignment notches along the bottom of the module where it plugs into
62
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
bezel and top cover.
top plate.
C4x)" on page 44 to remove the air duct.
connectors until they are both at a 45-degree angle. The memory module rises
slightly in the connector.
module is free from the connector.
the connector.
0
Updated July 14, 2008