Removing The Planar - IBM 4800-741 Hardware Service Manual

Removing the planar

Figure 44. Example of stand-offs
54
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
1. Follow the instructions in "Removing the covers" on page 29.
2. Follow the instructions in "Removing the top plate" on page 32.
3. Follow the instructions in "Removing the riser card" on page 49 and "Removing
the I/O modules" on page 42.
4. If installed, remove the air duct. See "Removing the air duct (Models 722, 74x,
78x, and C4x)" on page 44.
5. Follow the instructions in "Removing the processor fan (Models 742, 782
only)" on page 45
6. Remove the eight standoffs (see A in Figure 44) for the parallel, video and
serial ports.
7. Unplug all attached cables.
Note: For Models 742 and 782, disconnect the connector from the processor
power cable (see A in Figure 37 on page 48).
Updated July 14, 2008
A