Figure 64. Disk drive failure
2. Determine which hard disk drive has failed by opening the detected hard drive
3. Initiate shutdown and power off the machine (Start, Shutdown, press the power
4. Continue with the steps described in "Replacing and rebuilding a hard drive" on
Method two: Entering RAID during start-up
1. Shutdown and reboot the machine (Start, Shutdown, press the power switch,
76
SurePOS 700 Series: SurePOS 700-721/741/781, 722/742/782 Hardware Service Guide
(see Figure 64). In the example, the detected hard drive's Device Port is 1;
therefore, the failed hard drive is located on Device Port 0.
switch, or follow the procedure for your business.)
page 77.
or follow the procedure for your business.)
Updated July 14, 2008