IBM 4800-741 Hardware Service Manual page 49

Updated July 14, 2008
Figure 19. Replacing the top cover
3. See Figure 19 and locate the metal holding clip, C , located in the rear center
To replace the top cover:
1. Hold the cover in position over the system unit so that the front is aligned with
2. Close the modesty cover by pressing downward on the door. Replace the bezel
of the top cover. Push this clip downward and push the cover backward a few
inches before lifting upward to remove.
the line on the metal top and drop the cover onto the machine. Slide the cover
forward to lock into place.
by aligning the hooks on the bottom of the bezel with the slots on the frame and
snapping the top into place.
Chapter 2. Removal and replacement procedures
C
31