Step 2. Wide Units Only: Installing The Expansion Housing And The Optional Ups; Removing The Retainer Bracket - IBM 4800-741 Planning, Installation, And Operation Manual

Updated October 31, 2007
Step 2. Wide units only: Installing the expansion housing and the
optional UPS
This procedure is for wide units only.
Figure 15. Removing the retainer bracket
1. See Figure 15. Remove the retainer bracket from the expansion housing as
follows:
a. Turn the retaining screw to the left to unlock the bracket from the housing.
b. Pull the bracket to the right and then lift out to remove it from the notches.
Chapter 2. Installation and system setup
27