IBM 4800-741 Hardware Service Manual page 77

Updated July 14, 2008
Figure 50. Prying the expansion housing latch upward
4. Locate the latch ( A in Figure 50) inside of the power supply housing. Using a
5. Push the power supply housing backward from the unit until it unlatches.
6. To install the expansion housing, reverse these procedures.
A
screwdriver, pry the latch upward.
Note: Before you install the expansion housing, be sure that the latch is flush
with the side of the housing, and not bent inward.
Note: Be sure the latch ( A in Figure 50) is engaged and the expansion
housing bracket is securely fastened.
Chapter 2. Removal and replacement procedures
59