Removing The Control Switch Card - IBM 4800-741 Hardware Service Manual

Updated July 14, 2008

Removing the control switch card

To remove the control switch card:
1. Follow the instructions in "Removing the covers" on page 29 to remove the front
Figure 35. Removing the control switch card
2. See Figure 35. Remove the screw ( A ) holding the card in place.
3. Lift the card from the unit.
4. Unplug the cable that is attached to the card connector ( B ).
5. To replace the card, reverse these procedures.
bezel and top cover.
A
B
Chapter 2. Removal and replacement procedures
47