Removing The Spline - IBM 4800-741 Hardware Service Manual

Updated July 14, 2008

Removing the spline

To remove the spline:
1. Follow the instructions in "Removing the covers" on page 29 to remove the front
2. Follow the instructions in "Removing the top plate" on page 32 to remove the
Figure 29. Removing the spline
3. See Figure 29. Locate the spline and lift it upward from notch ( Z in Figure 29)
4. To replace the spline, reverse these procedures.
bezel and top cover.
top plate.
Z Z
and then outward from notch ( W ).
Chapter 2. Removal and replacement procedures
W
41