Table 40. Post Error Beep Codes - Intel SC5650BCDP Technical Product Specification

Appendix C: POST Error Messages and Handling
Error Code
9506 ATA/ATPI component encountered a controller error.
95A6 PCI component encountered a controller error.
95A7 PCI component encountered a read error.
95A8 PCI component encountered a write error.
9609 Unspecified software component encountered a start error.
9641 PEI Core component encountered a load error.
9667 PEI module component encountered a illegal software state error.
9687 DXE core component encountered a illegal software state error.
96A7 DXE boot services driver component encountered a illegal software state error.
96AB DXE boot services driver component encountered invalid configuration.
96E7 SMM driver component encountered a illegal software state error.
0xA022 Processor component encountered a mismatch error.
0xA027 Processor component encountered a low voltage error.
0xA028 Processor component encountered a high voltage error.
0xA421 PCI component encountered a SERR error.
0xA500 ATA/ATPI ATA bus SMART not supported.
0xA501 ATA/ATPI ATA SMART is disabled.
0xA5A0 PCI Express component encountered a PERR error.
0xA5A1 PCI Express component encountered a SERR error.
0xA5A4 PCI Express IBIST error.
0xA6A0 DXE boot services driver Not enough memory available to shadow a legacy option ROM.
0xB6A3 DXE boot services driver Unrecognized.
The following table lists POST error beep codes. Prior to system video initialization, the BIOS
uses these beep codes to inform users of error conditions. The beep code is followed by a user-
visible code on POST Progress LEDs.
Beeps Error Message
3 Memory error
The following Beep Codes are from the BMC, and are controlled by the Firmware team. They are listed here
for convenience.
1-5-2-1 CPU: Empty slot /
population error.
1-5-4-2 Power fault: DC
power
unexpectedly lost
(power good
dropout)
1-5-4-4 Power control fault
(Power good
assertion timeout)
58
Error Message

Table 40. POST Error Beep Codes

POST Progress Code
Multiple System halted because a fatal error related to the
memory was detected.
N/A CPU sockets are populated incorrectly – CPU1 must be
populated before CPU2.
N/A Power unit sensors – power unit failure offset.
N/A Power unit sensors – soft power control failure offset.
Intel order number: E80367-002
®
Intel Server System SC5650BCDP TPS
Description
Response
Minor
Minor
Minor
Minor
Minor
Minor
Fatal
Fatal
Fatal
Minor
Fatal
Major
Minor
Minor
Fatal
Minor
Minor
Minor
Fatal
Major
Minor
Major
Revision 1.5