Removing and Replacing the Transport Assembly (for Models 2/20, 4/40, and 6/60 only)
Replacing the Transport Assembly
1. If you are only replacing the transport assembly, remove the vertical
2. For Models 4/40 and 6/60, remove the 6-19 x .5 screws that secure the
Figure 2-14
Guide Blocks
3. Connect the umbilical cable to the motherboard (Figure 2-13 on page
Chapter 2
lift assembly from Models 4/40 and 6/60 to install on the replacement
transport assembly. See "Removing the Vertical Lift Assembly" on
page 2-48 for the procedure.
guide blocks to the top of the replacement transport assembly to
reattach the vertical lift assembly (Figure 2-14).
2-32). Ensure that it clicks into place.
Removing and Replacing Major Library Components
2-33