Table 2-7
Unique Parts for Model 12/140 (5 of 5)
Callout
Description
#
1
Top panel.
2
Filler panel. The panel is spring loaded at the top of the library cabinet when
there is space at the top of the cabinet.
3
Side panels. Use a 3/16 Allen wrench to remove the four captive fasteners on
each side panel. See "Accessing the Side Panels for Service" on page 2-36.
4
Library expansion card, which is located on level 5 of the library (see page 2-
18 for more information).
5
• Front side panels on library: Uses 4-40 screws to attach. See "Accessing
the Side Panels for Service" on page 2-36.
• Back side panels on library: Uses 4-40 screws to attach. See "Accessing the
Side Panels for Service" on page 2-36.
6
Lift cover bottom panel. Two captive T-20 bit screws (one on each side) secure
the panel to the cabinet. See "Accessing the Side Panels for Service" on page
2-36.
7
Lift assembly with jack and handwheel.
8
Power distribution unit: Uses 10-32 screws to attach. See "Removing and
Replacing the Power Distribution Unit (for Model 12/140 only)" on page 2-65.
NOTE
Not all the parts listed above are set up as FRUs (Field Replaceable
Units). Some of these components are service parts that are not stocked.
Chapter 2
Removing and Replacing Major Library Components
Exploded Views of Replaceable Parts (FRUs)
2-17