HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions page 106

NOTE
Downloading Firware and Interpreting LEDs
Upgrading Firmware
7. This step is for upgrading drive firmware only. If upgrading library
firmware, continue to step 8.
Ensure that the drive is online (green LED is on, and yellow LED is
off). If not, place it online through the front panel.
a. Enter the
Service
b. Select the drive and
The library will automatically run a self-test when the drive has been
brought online. Wait until the self-test completes, and then scan the
SCSI bus or restart the diagnostics program.
8. Download the firmware to the devices using the diagnostic tool.
9. Power off the library.
When downloading drive firmware, you must power cycle the library for
the download to be completed.
10. Disconnect the laptop and reconnect to the host system. Be sure to
match the original cabling and termination setup.
11. Power on the library and verify the device can be accessed from the
host.
3-6
then the
Online Drive Repair
.
[Put Drive Online]
menus.
Chapter 3