Replacing A Card - HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions

6. Loosen the two thumbscrews on the card with a screwdriver or by
7. Remove the card by pulling it outward.

Replacing a Card

1. Align the top and bottom edges of the replacement card with the card
2. Gently push the replacement card into the library until the card is
3. Tighten the thumbscrews (finger tight).
4. Reconnect the external cables.
5. Power on the library.
6. Download new firmware. See "Upgrading Firmware" on page 3-2
If the new card has a different version of firmware than the rest of the
NOTE
library, the library could go into a partial availability state due to a
firmware mismatch. When this occurs, the front panel will display
Available
amber. This is not an indication of a failure, but indicates that you need
to download new library firmware.
7. Configure the library.
Chapter 2
hand.
slots.
flush with the library.
, and the LED bar beneath the front panel display will be solid
• If installing a remote management card, see "Configuring the
Remote Management Card" on page A-2.
• If installing Fibre Channel, you may need to configure the library
from the front panel. See "Configuring the Library for Fibre
Channel" on page A-4 for more information.
Removing and Replacing Major Library Components
Removing and Replacing Cards
Partly
2-19