HP A5585A - SureStore DLT E Tape Library 4/40 Upgrade And Replacement Instructions page 55

3. Tighten the top and bottom thumbscrews, securing the drive module
4. Reconnect the ribbon connector back inside the drive module (Figure
5. Gently fold the ribbon cable (attached to the plate and SCSI cable)
6. Holding the connector plate in place, tighten the thumbscrews on
7. Bring the new drive module online using the front panel display by
NOTE If the new drive has a different firmware revision than the drives that are
already in the library, the library could go into a partial availability state
due to a firmware mismatch. When this occurs, the front panel will
display
will be solid amber. Download drive firmware until all drives have the
same firmware revision.
You may need to use the host backup software to recognize the new drive
NOTE
when bringing it online. If the software does not have the capability to
automatically detect the new drive, you may need to reboot the host.
Chapter 2
into the library.
2-8 on page 2-23).
into the back of the drive module.
each side of the connector.
following these steps:
a. Enter the or
Service
menus.
b. Select the drive module that has been replaced or installed, and
press .
[OK]
c. Select
[Put Drive Online]
d. If you have increased the number of drives since the last power
cycle or if you downloaded new drive firmware, power cycle the
library.
The library will automatically run a self test when the drive has been
brought online.
When the drive is successfully brought online, the new drive will
adopt the SCSI ID of the current drive position. The library will also
confirm the new drive is online in the
menu.
, and the LED bar beneath the front panel display
Partly Available
Removing and Replacing Major Library Components
Removing and Replacing Drive Modules
then the
Administration
.
Service/Online Drive Repair
Online Drive Repair
2-27