Soundoff Signal nFUSE Installation Instructions Manual page 24

nFUSE ECE Lightbar
®
WARRANTY & RETURN GOODS PROCEDURE
CLEANING & CARE OF YOUR LIGHTBAR:
Keeping the lenses clean and scratch free will optimize the
performance of the lightbar.
including lenses should be cleaned with mild soapy water and
a soft cotton cloth to remove dirt, grime and insects. Never
use window cleaners or harsh chemicals on the lenses; this
may cause failure of the lenses or reduce clarity resulting in the
reduction of light output.
MOUNTING INTEGRITY:
A review of bolt/hardware/mounting bracket integrity should be
performed at the beginning and end of each shift.
WARNING MESSAGES - PLEASE READ:
WARNING - DRILLING ANY HOLES INTO THE LIGHTBAR IS
NOT RECOMMENDED! THE RISK OF DAMAGING INTERNAL
COMPONENTS AND THE RESULTING FAILURE OF THE LIGHTBAR
WILL VOID ANY WARRANTY OF THIS PRODUCT.
WARNING - CARE MUST BE TAKEN WHEN DRILLING THROUGH
THE ROOF OF THE VEHICLE NOT TO DRILL INTO ANY EXISTING
WIRING AND NOT TO DRILL THROUGH THE HEADLINER OR
SUPPORT MEMBERS OF THE VEHICLE. CHECK BOTH SIDES
OF THE MOUNTING SERVICE PRIOR TO DRILLING. DE-BURR
ANY HOLES AND REMOVE ANY METAL SHARDS OR REMNANTS.
INSTALL GROMMETS INTO ALL WIRE PASSAGE HOLES.
WARNING - ROUTE WIRES ONLY IN LOCATIONS THAT ARE
NOT SUBJECTED TO POTENTIAL WEAR. MAKE SURE TO AVOID
ROUTING WIRES IN THE DEPLOYMENT AREA OF YOUR AIR BAG.
REFER TO YOUR VEHICLE OWNER'S MANUAL FOR AIR BAG
DEPLOYMENT ZONES.
WARNING - ALL CUSTOMER SUPPLIED POWER WIRES
CONNECTING TO THE POSITIVE (+) OR NEGATIVE (-) BATTERY
TERMINAL OR LOCAL CHASSIS GROUND (-) MUST BE SIZED
TO SUPPLY AT LEAST 125% OF THE MAXIMUM CURRENT AND
PROPERLY FUSED AT THE POWER SOURCE WITH APPROPRIATELY
RATED FUSE.
IMPORTANT: When passing cables through fire wall or other
sheet metal, insert grommet to protect the cable!
24
800-338-7337 | soundoffsignal.com
The exterior of the lightbar
WARRANTY RETURN PROCESS:
Please scan QR code or visit
https://soundoffsignal.com/support-page/returns/.
Alternatively contact your SoundOff Signal Sales Representative,
Customer Services staff or our Technical Department (800.338.7337)
for a RMA #, Return Merchandise Authorization Number.
The following information is required for issuance of the RMA #:
• Reason for returning the product*
• Address where replacement product is to be shipped*
• Telephone number where you may be reached*
• SoundOff Signal invoice number on which product was
purchased**
• SoundOff Signal part number and serial number**
• E-mail address where RMA # should be e-mailed**
• Fax number where RMA # should be faxed**
* RMA # will not be given without this information.
** If available, please provide this information.
SoundOff Signal will NOT accept returns without an RMA #. Each
RMA # is good for only one (1) return and will expire (30) days after
the date it was issued. Products must be shipped back to SoundOff
Signal and the RMA # clearly marked on the outside of the package
near the shipping label. Please use the following address on your
shipping label:
SoundOff Signal
ATTN: RMA # / Technical Services
3900 Central Parkway
Hudsonville, MI 49426
WARRANTY EXCLUSIONS:
Shipping & Handling, labor and service fees are non-refundable.
SoundOff Signal is not liable for any damage due to installation or
personal injury as a result of using SoundOff Signal product.
WARRANTY FORFEITURE:
Warranty will not be granted if the Warranty Return Policy &
Procedure rules are not strictly followed. Physical damage resulting
from customer abuse will void warranty. Warranty will also be
voided if any SoundOff Signal and/or manufacturer serial tags,
product stickers, seals, or the like, are removed, altered or tampered
with. Returned product that is damaged by shipping via the RMA #
procedure is not the responsibility of SoundOff Signal.
Document effective date on cover and below supersedes previously
dated policies and statements.
There are no other warranties, expressed or implied, including, but
not limited to, any implied merchantability or fitness for a particular
use. SoundOff Signal reserves the right to modify this warranty
statement at any time; or to discontinue, modify, or upgrade any
products of its manufacture with design improvements without
prior notice.
nFUSE ECE Lightbar English
®
0000KP 0325 REV A