Soundoff Signal nFUSE Installation Instructions Manual page 2

nFUSE ECE Lightbar
®
IMPORTANT NOTICE TO INSTALLER:
• Make sure to read and understand all instructions and warnings before proceeding with the installation of this product.
Ensure that the manual and any warning cards are delivered to the end user of this equipment. Proper installation of the
lightbar requires the installer to have a thorough knowledge of automotive electronics, systems, and procedures.
• Lightbars provide an essential function of an effective visual warning system. The use of the lightbar does not insure
that all drivers can or will abide by or react to an emergency warning signal, especially at high rates of speeds or long
distances. The operator of the vehicle must never take the right of way for granted and it is the operator's responsibility
to proceed safely.
• The effectiveness of the lightbar is highly dependent on the correct mounting and wiring. The installer must read and
follow the manufacturer's installation instructions and warnings in the manual. The vehicle operator should verify daily that
the lightbar is securely fastened to the vehicle and properly functioning before operating vehicle.
• The lightbar is intended for use by authorized personnel only. It is the user's responsibility to ensure they understand and
operate the emergency warning devices in compliance with the applicable city, state and federal laws and regulations.
SoundOff Signal assumes no liability for any loss resulting from the use of this warning device.
WARNING
!
• This product contains high intensity LED devices to prevent eye damage, DO NOT stare into the light beam at close range.
IMPORTANT INFORMATION:
• To view the full Software Revision History click the
application.
• Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
• DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to your vehicle Owner's Manual for
the location of any air bag deployment zones.
• DO NOT connect this device to a strobe power supply. This product is self-contained and does not require an external
power supply.
WARNING
!
• Route wires only in locations that are not subjected to potential wear. Make sure to avoid routing wires in the deployment
area of your airbag. Refer to your vehicle's owner's manual for airbag deployment zone.
• All customer supplied power wires connecting to the positive (+) or negative (-) battery terminal or local chassis ground (-)
must be sized to supply at least 125% of the maximum current and properly fused at the power source with appropriately
rated fuse.
NOTICE:
• Installers and users must comply with all applicable local laws and regulations regarding use.
• Improper use or installation may void warranty coverage.
• To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/tech-services/returns/.
• If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. ET at 800-
338-7337 (press #4).
• Questions or comments that do not require immediate attention may be emailed to techgroup@soundoffsignal.com.
2
800-338-7337 | soundoffsignal.com
in the lower left hand corner of the SoundOff Central Lightbar
nFUSE ECE Lightbar English
®
0000KP 0325 REV A