Generac Power Systems MLTS Owner's Manual page 31

Operation
Prestart Checklist
Before starting the unit, all items in the prestart checklist
must be completed. This checklist applies to both manual
and remote starting of the unit.
WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.

Verify all maintenance procedures are up to date. For
more information, refer to
Basic Maintenance Schedule.

Perform a walk-around inspection. Refer to
Walk-Around Inspection.

The unit must be level.
 The unit must be dry. Inspect for water inside or near
the unit; dry if needed.
 For grounding requirements, follow the National
Electrical Code (NEC), state, and local regulations.
 Verify the control power switch is OFF (O).

Verify all circuit breakers are OFF (O).
 Inspect all electrical cords; repair or replace any that
are cut, worn, or bare.

Verify all winch cables are in good condition and
centered on each pulley. Do not use if cables are
kinked or beginning to unravel.
 Check oil, coolant, and fuel levels. For more
information, refer to General
 Verify battery connections are secure.

Turn the battery disconnect switch on, if equipped.
 Inspect the engine fan belt tension and condition.

Inspect the engine fan belt guard.
 Inspect the engine exhaust system for loose or
rusted components.
 Verify all covers are in place and secure.
26
(000100a)
and
General Maintenance
Daily
Maintenance.
Starting Unit—Analog Controls
CAUTION
Equipment Damage. Do not continuously crank
engine for more than ten seconds. Doing so will lead
to overdischarge of batteries and starter seizure.
NOTE: If the engine was run out of fuel or the fuel tank
was drained, it may be necessary to purge the fuel lines.
Refer to the engine operator's manual supplied with the
unit.
1. Open unit hood.
2. See Figure 3-4. Switch the flex switch (if equipped)
to position 2.
Figure 3-4. Flex Switch—Position 2
3. Close unit hood.
4. See 3-5. Switch lights to OFF (O).
Figure
Figure 3-5. Lights OFF (O)
5. See
Figure 3-6. Switch main AC circuit breaker to
OFF (O).
Figure 3-6. Main AC Circuit Breaker OFF (O)
Owner's Manual for Mobile Light Tower
(000230)
MAIN AC
CIRCUIT
BREAKER
010585
010586
010587