Generac Power Systems MLTS Owner's Manual page 12

Safety and Operating Decals
See Figure 1-1 through
numerous safety and operating decals. These decals
provide important operating instructions and warn of
dangers and hazards. The following diagrams illustrate
decal locations and descriptions.
ID Description
1 Setup and Take-Down Instructions (Electric)
2 Setup and Take-Down Instructions (Manual)
3 Danger—Overhead Power Lines
4 Warning—Electrical Storms and High Wind
5 Owner's Manual Location
6 Electric Shock Hazard
7 Warning—Hot Surface
8 Warning—Pressurized Liquid
9 Warning—Entanglement Hazard
10 Warning—Cutting Hazard
11 Disconnect Battery Before Servicing
12 FCC Label (MLTS-K Only)
13 Danger—Carbon Monoxide
14 Electrical Ground Connection
15 Notice—Winch Operation
Owner's Manual for Mobile Light Tower
Figure 1-3. This unit features Replace any missing or hard-to-read decals and use care
when washing or cleaning the unit. Decal part numbers
can be found in the parts manual.
ID Description
16 Warning—Diesel Exhaust
17 Control Panel Label (not shown)
18 Neutral Bonded to Frame
19 Not A Step
20 Warning—High Temperature: Do Not Remove Guard
21 Mast Junction Box Wiring (inside)
22 Warning—Do Not Retract Outriggers With Tower Up
23 Stowed Position
24 Lifting Point
25 Forklift and Tie-Down Point
26 Engine Operation
27 Danger—Fuel and Fueling Hazards
28 Ultra Low Sulfur Diesel Fuel Only
29 Tie-Down Point
30 Towing Instructions
Introduction and Safety
7