Wren Kitchens Infinity Plus Base Unit Fittings Manual page 5

Cutting the ducting cutout
Starting in the drilled corner, use a jigsaw to
carefully cut along the marking.
Sliding the back panel into place
After drilling the holes for the ducting, slide
the back panel into the grooves at the rear of
the unit.
Once the back panel is in position, secure it
by using 3 small tacks along the base panel.
Ensure the tacks are placed in different
locations than the original staples, to avoid
weakening the material.
Positioning the leg brackets
Locate the leg brackets and position, as
shown in the diagram. Ensure the leg
brackets are rotated so the flange covers the
outer edge, as this provides support for the
edge of the unit.
Page 5