Page 2
BASE UNIT Hob 2 Drw, 3 Drw & 2 Drw inc Dummy Assembly Guide BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Standard Drawer (Packed Separately) Fitting Pack Contents METAL BACK PANEL (J) x16...
Page 3
Step 1. Secure drawer base to drawer side using 4 x 16mm drawer runner screws (J) in holes provided. Seat the edge of drawer base tight Drawer into corner of casing, as shown. base The decorative face of drawer base to be positioned as shown.
Page 4
BASE UNIT Hob 2 Drw, 3 Drw & 2 Drw inc Dummy Assembly Guide Step 1. Secure drawer base to drawer side using 4 x 16mm drawer runner screws (J) in holes provided. Drawer base Seat the edge of drawer base tight Metal white decorative back...
Page 5
BEFORE YOU START INSTALLATION SHOULD BE PERFORMED BY A COMPETENT PERSON ONLY. THIS PRODUCT COULD BE DANGEROUS IF INCORRECTLY INSTALLED Panel A Panel B Panel C Panel E Metal Frontal Rail x1 Back Panel x2 End Panel x1 Base Panel x1 Rail (Packed separately) Qty as per order...
Page 6
BASE UNIT Hob 2 Drw, 3 Drw & 2 Drw inc Dummy Assembly Guide Step 1. To attach drawer runner screw into end panels (B) using 2 x 16mm screws (J) Panel B per drawer rail, into pilot holes provided, as shown. Drawer runner bracket screw position Step 2.
Page 7
Step 3. Seat dowel (F) into holes in Step 4. both end panels (B) as shown. Seat cam dowel (G) into holes in Seat (G) cam dowel both end panels (B) as shown. into hole as shown. Metal Rail Metal Rail Insert Insert Dowel (F), Cam Dowel (G)
Page 8
BASE UNIT Hob 2 Drw, 3 Drw & 2 Drw inc Dummy Assembly Guide Step 7. Slide back panel (A) into groove of end panels (B). The back panel (A) is to be modified accordingly to suit Customer Requirements, prior to inserting into unit.
Page 9
Step 10. Position legs as shown. Ensure legs are rotated to also provide support to the end panels (B). 600-800 width unit, 4 legs 1000 width units, 5 legs. Step 11. Secure each of the legs into place with 4 x 15mm screws (L) per leg.
Page 10
BASE UNIT Hob 2 Drw, 3 Drw & 2 Drw inc Dummy Assembly Guide Screw into any side units using the 30mm screws (K) provided to secure to the unit. Screw just to the rear of the indentations at the top and bottom on both sides of the unit where applicable.
Page 11
Dummy Drawer Frontal Fixing (Where Applicable) Drawers Supplied in accordance to Specific Customer Kitchen Plan 2 Drawer inc Dummy Drawer Step 1. Secure 2 x dummy fixing clip parts (B) onto the inside face of dummy drawer front, 22mm from the edge spaced evenly either side as shown, using 21mm screws provided.
Need help?
Do you have a question about the Vogue BASE UNIT 600 2 Drawers Dummy and is the answer not in the manual?
Questions and answers