Advertisement
Communications
In the 'Status' section, the user can see the current state of Ethernet, Modem
and Wi-Fi, and more relevant information about each one.
The following diagram shows an approximated range of signal strength
that can be obtained depending on the location of the Charge Point.
-50 dBm
Good signal
In the 'Ethernet' section, if DHCP is enabled, an automatic IP address will be
assigned.
Otherwise, you must manually configure the IP address.
The hostname can also be modified.
-80 dBm
Moderate signal
-90 dBm
-100 dBm
Bad signal
33
Advertisement
Need help?
Do you have a question about the eVolve Smart Series and is the answer not in the manual?
Questions and answers