Table of Contents
Advertisement
3-6-1. X/Z collection
3-6-1-1. X collection processing
3-6-1-2. Z collection processing
NOTE:
QT-6600 Reference Manual
This function is used to obtain the counters and totals of the individual terminals.
X collection processing is performed as the figure shown below.
Satellite
Terminal
files
2
1 An X collection command is started up from the master terminal.
2 One objected terminal sends its report data to the consolidation work file of the master.
3 Report data from the objected terminal file are printed out on the master's printer.
4 After processing of the master terminal completes, the same processes described in the
item 1 to 3 are executed for the other terminals. Data will be sent without the clerk
noticing, even when the satellite in the process of registering.
Z collection processing is performed as the figure shown below.
1, 4
Satellite
Terminal
files
2
1 When a Z collection command is started up from the master terminal, the master first
locks one objected terminal. (Z lock)
2 The objected terminal sends its report data to the consolidation work file of the master
terminal.
3 Report data from the satellite terminal file are printed out on the master's printer.
4 The same processes described in the item 1 to 3 are executed for the other terminals.
5 After the processing of the master terminal completes, the data of objected terminal file
are cleared, and then the Z lock of the objected terminal is released.
• When a Z collection is performed, the consolidation data cannot be output. If output of
consolidation data is desired, perform "collection/consolidation" processing described
later.
• Even if an error is occurred, or if the processing is terminated, the data to be collected
remains as they are, and Z lock statuses are automatically released.
1
Master
Terminal
files
2
Consolidation
work
Master
Terminal
3
files
2
Consolidation
work
3
R-123
Advertisement
Table of Contents
