Solving Problems Described By Lcd Status Messages (Optional); Removing Lcd Status Messages (Optional) - Dell PowerEdge E07S Series Owner's Manual

Table 1-2. LCD Status Messages (Optional) (continued)
Code Text
W1627 Power required
> PSU wattage.
Check PSU and
config.
W1628 Performance
degraded.
Check PSU and
system
configuration.
NOTE:
For the full name of an abbreviation or acronym used in this table, see the
Glossary at support.dell.com/manuals.

Solving Problems Described by LCD Status Messages (Optional)

The code and text on the LCD can often specify a very precise fault condition
that is easily corrected. For example, if the code E1418
appears, you know that a microprocessor is not installed in socket 1.
In contrast, you might be able to determine the problem if multiple related
errors occur. For example, if you receive a series of messages indicating
multiple voltage faults, you might determine that the problem is a failing
power supply.

Removing LCD Status Messages (Optional)

For faults associated with sensors, such as temperature, voltage, fans, and so
on, the LCD message is automatically removed when that sensor returns to a
normal state. For example, if temperature for a component goes out of range,
the LCD displays the fault; when the temperature returns to the acceptable
range, the message is removed from the LCD. For other faults, you must take
action to remove the message from the display:
Causes
The system configuration
requires more power
than what the power
supply can provide.
The system configuration
requires more power
than what the power
supply can provide, but it
can boot if throttled.
Corrective Actions
Turn off power to the
system, reduce the
hardware configuration or
install higher-wattage
power supplies, and then
restart the system.
Turn off power to the
system, reduce the
hardware configuration or
install higher-wattage
power supplies, and then
restart the system.
CPU_1_Presence
About Your System
37