Installing A Processor - Dell PowerEdge E07S Series Owner's Manual

Installing a Processor

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 If you are upgrading your processor, prior to upgrading your system,
download and install the latest system BIOS version from
support.dell.com. Follow the instructions included in the file download to
install the update on your system.
2 Unpack the processor if it has not been used previously.
If the processor has already been used, remove any thermal grease from the
top of the processor using a lint-free cloth.
3 Align the processor with the socket keys on the ZIF socket.
See Figure 3-20.
CAUTION:
system board or the processor. Be careful not to bend the pins in the socket.
4 With the release lever on the processor socket in the open position, align
the processor with the socket keys and set the processor lightly in the
socket.
CAUTION:
positioned correctly, it engages easily into the socket.
5 Close the processor shield.
6 Rotate the socket-release lever down until it snaps into place.
7 Using a clean lint-free cloth, remove the thermal grease from the heat sink.
8 Open the grease packet included with your processor kit and apply thermal
grease evenly to the center of the top of the new processor.
CAUTION:
processor shield, which can cause contamination of the processor socket.
9 Place the heat sink on the processor. See Figure 3-19.
10 Using a #2 Phillips screwdriver, tighten the heat-sink retention screws.
See Figure 3-19.
124
Installing System Components
Many repairs may only be done by a certified service technician. You
Positioning the processor incorrectly can permanently damage the
Do not use force to seat the processor. When the processor is
Using excess thermal grease can cause grease to contact the